Installation

INSTALLATION

CAUTION:
^ Be sure to use a new flange nut and self-locking nut.
^ Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.

1) Install each part in the reverse order of removal.

Tightening torque:
Refer to "COMPONENT" of "General Description" for the tightening torque. Rear Suspension

2) Install the rear wheels.

Tightening torque:
120 Nm (12.24 kgf-m, 88.5 ft-lb)

3) Check the wheel alignment and adjust it if necessary. Service and Repair

CAUTION:
When the wheel alignment has been adjusted, perform the 0 point setting mode for each sensor in the VDCCM&H/U.