Power Seat System
Power Seat SystemREMOVAL
CAUTION: When removing the front seat, Disconnect the ground cable from battery before disconnecting the side airbag module harness connector, and wait for 60 seconds before starting the operation.
1. POWER SEAT SWITCH
1. Remove the seat from vehicle.
2. Remove the seat side cover OUT.
1. Release the claw in the rear section of the seat side cover.
2. Release the claw in the upper section of the seat side cover.
3. Remove the clip and release the claw in the front section of the seat side cover
4. Disconnect the power seat switch and lumber switch connectors and remove the seat side cover OUT.
3. Remove the screws to remove the power seat switch assembly.
2. LUMBAR SWITCH
1. Remove the seat from vehicle.
2. Remove the seat side cover OUT.
1. Release the claw in the rear section of the seat side cover.
2. Release the claw in the upper section of the seat side cover.
3. Remove the clip and release the claw in the front section of the seat side cover
4. Disconnect the power seat switch and lumber switch connectors and remove the seat side cover OUT.
3. Disconnect the connector and remove the lumbar switch assembly.
3. SEAT MEMORY SWITCH
1. Disconnect the ground cable from battery.
2. Remove the gusset cover.
1. Attach the protective tape (a) to the door trim.
2. Release the clips and claws, then detach the gusset cover.
3. Remove the door trim assembly.
1. Open the cover and remove the screw.
2. Remove the clips in the order of (A) to (J) and remove the door trim assembly from the door panel.
CAUTION: When removing the door trim, be sure to remove the clips in the correct order. Forcibly removing clips may damage the door panel assembly.
NOTE: Insert a plastic clip remover into the slit at the bottom of the door trim, to lift the door trim.
3. Remove the cables (a) and (b) from the cable holder of inner remote.
4. Disconnect the harness connector and remove the door trim assembly.
4. Release the claws, and remove the seat memory switch assembly.
4. POWER SEAT CONTROL MODULE (SEAT WITH MEMORY FUNCTION)
1. Raise the seat cushion by operating the switch.
2. Remove the front seat from the vehicle.
3. Remove the power seat control module.
1. Release the hooks on seat front and turn over the cushion cover.
2. Remove the nuts, and remove the power seat control module.
INSTALLATION
Install each part in the reverse order of removal.
Tightening torque:
Power seat control module: 5.9 N.m (0.60 kgf-m, 4.4 ft-lb)
NOTE:
- The seat with memory function must be initialized after installed.
- After replacing a seat with memory function and the power seat control module, check the following items.
1. Memory is reloaded when the ignition is ON and the select lever is shifted to "P" range.
2. Memory is not reloaded even if the seat memory switch is pressed, when the ignition is ON and the select lever is set to other than "P" range.
3. Memory is reloaded when the ignition is OFF and the driver's door inner switch is pressed within 45 seconds after the door is opened.
4. Memory is reloaded automatically when the ignition is OFF and the driver's door is opened after unlocked by access key. (model with smart key interlock function)