Cylinder Head Assembly
Cylinder Head BoltsPlease refer to Cylinder Head Removal and Installation for bolt tightening sequence and specifications. Service and Repair
Cylinder Head Inspection
Check for warpage at mating surface between the cylinder block and cylinder head using a straight edge (A) and thickness gauge (B). If the warpage exceeds limit, replace the cylinder head.
Warping limit 0.020 mm (0.0008 in)
Standard height of cylinder head 124 ± 0.05 mm (4.88 ± 0.0020 in)
Camshaft Cap Bolts
Gradually tighten the camshaft cap in at least two stages in the numerical order shown in the figure, then tighten to specified torque.
Tightening Torque
(1) - (12) 16 Nm (1.6 kgf-m, 11.8 ft-lb)
(13) - (17) 9.75 Nm (1.0 kgf-m, 7.2 ft-lb)
Camshaft Sprocket Bolts Specifications