Installation

INSTALLATION

1) Check the control valve body for dust and other foreign matter.
2) Install the control valve body to transmission by equally tightening the bolts.

Tightening torque:
8 Nm (0.8 kgf-m, 5.9 ft-lb)





3) Connect the control valve connector and front vehicle speed sensor connector.





4) Attach the magnet at the specified position of the oil pan.





5) Apply liquid gasket to the oil pan.

Liquid gasket:
THREE BOND 1217B (Part No. K0877YA020) or equivalent





6) Install the oil pan by equally tightening the bolts.

Tightening torque:
5 Nm (0.5 kgf-m, 3.7 ft-lb)

7) Lower the vehicle.
8) Connect the ground cable to battery.
9) Pour ATF through the oil charge pipe. Inspection
10) Check the ATF level. Inspection
11) Perform Clear Memory 2 operation. Clearing Diagnostic Trouble Codes
12) Perform learning operation. Programming and Relearning
13) Perform the inspection at the end of repair work, and make sure there is no faulty as below;
^ Excessive shift shock
^ Oil leakage from the transmission body, etc.
^ Occurrence of noise caused by interference etc.