Front Seat

Front Seat


FRONT SEAT (DRIVER'S SEAT)







FRONT SEAT (PASSENGER'S SEAT)







REMOVAL

CAUTION:
The airbag system is fitted with a backup power supply. After disconnecting the battery ground cable, the airbag may deploy if you do not wait for 60 seconds before starting the service of airbag system.

NOTE:
- If a front seat is power seat with memory function, the memory function must be initialized after installing seat to the vehicle.
- If it is not initialized, the memory function may not operate properly.

1. DRIVER'S SEAT

1. Remove the headrest.
2. Tilt the backrest forward, and move the seat forward.
3. Remove the rear leg cover, and remove the two bolts at the rear side of slide rail.
4. Move the seat backward, remove the front leg cover, and then remove the 2 bolts at the front side of the slide rail.
5. Disconnect the ground cable from battery, and wait for 60 seconds or more before starting work.
6. Disconnect the connector under the seat.
- Seat belt buckle switch connector
- Side airbag connector
- Seat heater connector
- Power seat connector

7. Remove the seat from vehicle.

2. PASSENGER'S SEAT

CAUTION: Refer to "CAUTION" of "General Description" before starting the work.

1. Remove the headrest.
2. Tilt the backrest forward, and move the seat forward.
3. Remove the rear leg cover, and remove the bolt at the rear side of the slide rail.
4. Move the seat backward, remove the front leg cover, and then remove the bolt at the front side of the slide rail.
5. Disconnect the ground cable from battery, and wait for 60 seconds or more before starting work.
6. Disconnect all the connectors of connector holder in the backside of seat cushion.
- Harness connector of occupant detection control module
- Side airbag connector
- Power seat connector
- Seat heater connector

7. Remove the seat from vehicle.


INSTALLATION

CAUTION:
- For a power seat with memory function, if a front seat is removed, the memory function must be initialized after installing the seat to the vehicle.
- If it is not initialized, the memory function may not operate properly.

Install in the reverse order of removal.

NOTE: Tighten the slide rail installing bolts in the order as shown in the figure, in several steps by gradually increasing the torque until they reach the specified torque.







Tightening torque:
Refer to "COMPONENT" of "General Description". [Ref. to COMPONENT, General Description.]