Power Seat System
Power Seat SystemREMOVAL
CAUTION: When removing the front seat, disconnect the ground cable from the battery before disconnecting the side airbag module harness connector, and wait for 60 seconds before starting the operation.
1. POWER SEAT SWITCH
1. Detach the connectors and remove the seat side cover outside.
2. Remove the screws to remove the power seat switch assembly.
NOTE: Perform the same procedure when removing the memory switch of memory-equipped seat.
2. MEMORY MODULE (MEMORY-EQUIPPED SEAT)
1. Lift the seat cushion by operating the switch.
2. Remove the front seat from the vehicle.
3. Remove the nut and then remove the memory module.
INSTALLATION
Install in the reverse order of removal.
NOTE:
- For the memory-equipped seat, always perform the initialize operation after the installation.
- Check the following items after replacing the memory-equipped seat or the memory module.
1. Memory feature is restored after turning the ignition switch to ON and shifting to P range.
2. Memory feature is not restored after turning the ignition switch to ON and shifting to other than P range.