Float Level

Fig. 7 Float level adjustment:

1. With carburetor installed on engine, inspect fuel level through float bowl sight glass.
2. If fuel level is not within round mark on sight glass, remove air horn to adjust float.
3. Invert air horn, then raise and lower float, allowing it to rest on needle valve.
4. Measure clearance between air horn gasket surface and toe of float, Fig. 7, with air horn gasket removed.
5. If clearance is not as specified in ``Adjustment Specifications,'' adjust float level by bending tongue of float up or down as needed.
6. After adjusting float, reinstall air horn and recheck fuel level in float bowl.