Ignition Control Module: Testing and Inspection

Fig. 15 Checking Ignition Igniter:

1. Remove dust cover from igniter and disconnect red and white wires.
2. Connect ohmmeter, test lamp, and 12 volt battery as shown in Fig. 15.
3. Set ohmmeter to 1--10 ohm range. Connect negative probe to red wire terminal of igniter and positive probe to white wire terminal. If test lamp illuminates, igniter is satisfactory. If not, replace igniter. Ohmmeter leads should only be connected as outlined above. Reversing leads may cause damage to igniter.
4. Connect red and white wires to igniter and install dust cover.