Disassembly

Fig. 2 Removing Nut From Bevel Pinion Shank:

Fig. 3 Separating Differential Case Halves:

Fig. 4 Removing Side Bearing From Differential Case Half:

1. Using holder 09930-40113 (A), Fig. 2, remove nut from end of bevel pinion shank.
2. Scribe identification marks on each cap bolted to the saddle portion of carrier case and the caps holding down the side bearings.
3. On each side, loosen bolts on bearing adjuster stopper and remove bearing cap attaching bolts, then bearing cap.
4. Remove differential case assembly from carrier.
5. Remove ten bolts attaching bevel gear to differential case, then separate gear from case.
6. Using holder 09930-40113 (A), Fig. 3, remove eight bolts securing the two differential case halves, then separate case halves.
7. Remove side gears, differential pinions and thrust washers.
8. Using puller 09913-60910 (A) and adapter 09913-85230 (B), Fig. 4, remove side bearing from each differential case half.
9. Using a suitable puller and an arbor press, remove inner race of bevel pinion bearing.