Installation

Reverse removal procedure to install, noting the following:
- Tightening torque is as follows:
(a) 85 Nm (61.5 ft. lbs.)
(b) 50 Nm (36.5 ft. lbs.)
(c) 50 Nm (36.5 ft. lbs.)
(d) 50 Nm (36.5 ft. lbs.)
(e) 50 Nm (36.5 ft. lbs.)
(f) 55 Nm (40.0 ft. lbs.)
- For tightening torque of transmission stiffener bolt, refer to Engine.
- Set each clamp for wiring, hose and cable securely.
- Set clamp for shift control lever boots securely.





- After connecting clutch cable, be sure to adjust its play properly.
Arm Play "a": 0.5-1.5 mm (0.02-0.06 inch)
Pedal play: 15-25 mm (0.6-1.0 inch)
- Fill gear oil to transmission and transfer as specified.
- Connect battery and check function of engine, clutch and trans.
- When installing propeller shaft, align the match marks.