2-Door

1. Relieve fuel system pressure as outlined under Technician Safety Information.
2. Disconnect battery ground cable, then remove the following components from engine compartment:
a. Wiring harness couplers, breather hose clamp, kickdown cable, vacuum hose, transmission to engine bolts and starter.

3. Raise and support vehicle.
4. Drain transfer oil into appropriate container.
5. Remove front and rear propeller shafts.
6. Release select cable by removing nut from end of cable and E-ring from bracket.
7. Remove select cable bracket, then disconnect oil cooler hoses from pipes.
8. Remove torque converter housing lower plate.
9. Holding driveplate stationary using gear stopper tool No. 09927-56010, or equivalent, remove plate attaching bolts.

10. Remove exhaust center pipe, then engine to transmission nuts.
11. Remove meter cable end nut and disconnect cable.
12. Support transmission using suitable jack, then remove rear mounting member bolts and member.
13. Remove transmission and transfer case from vehicle.
14. Remove transfer case attaching bolts, then separate transfer from transmission.
15. Remove torque converter from transmission.
16. Reverse procedure to install. Tighten to specifications.