Select Cable/Transmission Range Switch

SELECT CABLE/TRANSMISSION RANGE SWITCH





SELECT CABLE

ADJUSTMENT





1) Before tightening cable end nut, shift select lever to "N".
2) Also shift manual shift lever to "N".

NOTE:
- Make sure that nut and cable joint have clearance under above conditions.
- If select cable has been moved, push it in arrow C direction as shown in figure at the left till it stops and then confirm that select lever is in "N" position.





3) Turn nut A by hand till it contacts manual select cable joint.
Then tighten nut B with wrench.
4) After select cable was installed, check for the following.
- Push vehicle with select lever shifted to "P". Vehicle should not move.
- Vehicle can not be driven in "N".
- Vehicle can be driven in "D", "2", and "L".
- Vehicle can be backed in "R".

TRANSMISSION RANGE SWITCH

INSPECTION & ADJUSTMENT
1) Shift select lever to "N" range.





2) Fix transmission range switch with groove in shift switch and match mark on shaft aligned.
3) Check that engine starts in "N" and "P" ranges but it doesn't start in "D", "2", "L" or "R" range. Also, check that back-up lamp lights in "R" range.





4) If faulty condition cannot be corrected by adjustment, disconnect transmission range switch coupler and check that continuity exists as shown by moving select lever.