Engine Installation

INSTALLATION





1. Lower engine assembly into engine compartment and connect engine to transmission. Hand-tighten bolts and nuts fastening cylinder block and transmission.





2. Tighten engine mounting bracket bolts (R and L).
Tightening Torque (a): 50 Nm (5.0 kg-m, 36.5 ft. lbs.)





3. Tighten bolts fastening cylinder block and transmission to specified torque.
Tightening Torque (a): 85 Nm (8.5 kg-m, 61.5 ft. lbs.).
4. Remove lifting device.





5. Reverse removal procedure for installation, noting the following:
^ Tighten torque converter bolts to specified torque.
Tightening Torque (a): 65 Nm (6.5 kg-m, 47.0 ft. lbs.)





^ Tighten nuts fastening cylinder block and transmission and transmission stiffener bolts (left side for 4 A/T and M/T model) to specified torque.
Tightening Torque:
(a): 50 Nm (5.0 kg-m, 36.5 ft. lbs.)
(b): 85 Nm (8.5 kg-m, 61.5 ft. lbs.)





^ Tighten nuts and bolts of exhaust pipes to specified torque.
Tightening Torque (a): 50 Nm (5.0 kg-m, 36.5 ft. lbs.)





^ Tighten transmission stiffener bolts (right side) to specified torque.
Tightening Torque:
(a): 50 Nm (5.0 kg-m, 36.5 ft. lbs.)
(b): 29 Nm (2.9 kg-m, 21.0 ft. lbs.)





^ Tighten flare nut of fuel feed pipe to specified torque. Be sure to use back-up wrench.
Tightening Torque (a): 45 N m (4.5 kg-m, 32.5 ft. lbs.)
6. Adjust water pump drive belt tension.
7. Adjust power steering pump belt tension or A/C compressor belt tension, if equipped.
8. Adjust accelerator cable play and A/T kickdown cable (for 3 A/T model) or A/T throttle cable (for 4 A/T model).
9. Check to ensure that all removed parts are back in place. Reinstall any necessary parts which have not been reinstalled.
10. Refill engine with engine oil.
11. Refill cooling system.
12. Verify that there is no fuel leakage, coolant leakage and exhaust gas leakage at each connection.