Replacement

REMOVAL
1. Disconnect negative cable at battery.
2. Remove timing belt as previously outlined.





3. Remove generator and its bracket.

NOTE: When installing bracket, fasten bolt (A) first.





4. Remove power steering pump bracket or A/C compressor bracket, if equipped.

NOTE: When installing bracket, fasten bolt (B) first.





5. Remove crankshaft timing belt pulley and timing belt guide. To lock crankshaft, engage special tool (gear stopper) with flywheel ring gear (drive plate ring gear for A/T). With crankshaft locked, remove crankshaft timing belt pulley bolt.
Special Tool (A): 09927-56010 or equivalent.





6. Remove oil pan and oil pump strainer as previously out.





7. Remove oil pump assembly after removing bolts.

INSTALLATION
1. Install two oil pump pins and oil pump gasket to cylinder block. Use a new gasket.





2. To prevent oil seal lip from being damaged or upturned when installing oil pump to crankshaft, fit special tool (Oil seal guide) to crankshaft, and apply engine oil to special tool.
Special Tool (A): 09926-18210 or equivalent.





3. Install oil pump to cylinder block. As there are two types of oil pump bolts, refer to figure for their correct use and tighten them to specified torque.
Tightening Torque (a): 11 Nm (1.1 kg-m, 8.0 ft. lbs.).





4. Install rubber seal between oil pump and water pump.





5. Install timing pulley key and crank timing belt pulley. Refer to figure for proper installation of these parts. With crankshaft locked, tighten crank timing belt pulley bolt to specified torque.
Tightening Torque (a): 110 Nm (11.0 kg-m, 80.0 ft. lbs.).
Special Tool (A): 09927-56010 or equivalent.
6. Install timing belt, tensioner, oil pump strainer, oil pan and other parts as previously outlined.
7. Check to ensure that all removed parts are back in place. Reinstall any necessary parts which have not been reinstalled.
8. Adjust water pump drive belt tension.
9. Adjust power steering pump belt tensioner A/C compressor belt tension, if equipped.
10. Refill engine with engine oil.
11. Refill front differential housing with gear oil.
12. Connect negative cable at battery.
13. After completing installation, check oil pressure by running engine.