Without Scan Tool

DTC CHECK USING "AIR BAG" WARNING LAMP

1) Turn "ON" ignition switch and wait till "AIR BAG" warning lamp has flashed 7 times.





2) By using service wire, connect diagnosis switch terminal and ground terminal on "AIR BAG" monitor coupler
3) To read diagnostic trouble code, watch "AIR BAG" warning lamp. (For frequency of code signal, refer to page 9J-20).

If diagnostic trouble code is not indicated, check diagnosis switch circuit according to Chart F in page 9J-32.

NOTE:
- When there are 2 or more diagnostic trouble codes, all applicable code will be indicated from smaller number to large number in order.
- On-board diagnosis function is not possible to read history diagnostic trouble code or clear diagnostic trouble code.