System Specifications

Tightening Torque (a): 23 Nm (2.3 kg-m, 17.0 ft. lbs.).








a. Tighten all bolts to 35 Nm (3.5 kg-m, 25.0 ft. lbs.) according to numerical order in figure.
b. In the same manner as in 1), tighten them to 55 Nm (5.5 kg-m, 40.0 ft. lbs).
c. In the same manner as in 1) again, tighten them to specified torque.
Tightening Torque (a): 68 Nm (6.8 kg-m, 49.5 ft. lbs.)









Install crankshaft pulley. Fit keyway of pulley to key on crank timing belt pulley, and tighten five bolts to specified torque.
Tightening Torque (a): 16 Nm (1.6 kg-m, 11.5 ft. lbs.).







Install bearing cap to cylinder block, making sure to point arrow mark (on each cap) to crankshaft pulley side. Fit them sequentially in ascending order 1, 2,3,4 and 5, starting from pulley side. After installing bearing cap stiffeners, tighten bearing cap bolts in such order as shown in figure a little at a time and repeat it till they are tightened to specified torque.
Tightening Torque (a): 54 Nm (5.4 kg-m, 39.0 ft. lbs.).







Install flywheel Manual Transmission (M/T model) or drive plate Automatic Transmission (A/T model). Using special tool, lock flywheel or drive plate, and torque its bolts to specification.
Special Tool (A): 09924-17810 or equivalent
Tightening Torque (a): 78 Nm (7.8 kg-m, 56.5 ft. lbs.)