Component Tests and General Diagnostics: Diagnosis and Testing

ROAD TEST
Brakes should be tested on dry, clean, smooth and reasonable level roadway which is not crowned. Road test brakes by making brake applications with both light and heavy pedal forces at various speeds to determine if car stops evenly and effectively.
Also road test vehicle to see if it pulls to one side without brake application.If it does, check tire pressure, front end alignment and front suspension attachments for looseness.

BRAKE FLUID LEAKAGE INSPECTION
Check master cylinder fluid levels. While a slight drop in reservoir level does result from normal lining wear, an abnormally low level indicates a leak in the system. In such a case, check the entire brake system for leakage.
If even a slight evidence of leakage is noted, the cause should be corrected or defective parts should be replaced.

SUBSTANDARD OR CONTAMINATED BRAKE FLUID
Improper brake fluid, mineral oil or water in the fluid may cause the brake fluid to boil or the rubber components in the hydraulic system to deteriorate.
If deterioration of rubber is evident, disassemble all hydraulic parts and wash with alcohol. Dry these parts with compressed air before assemble to keep alcohol out of the system. Replace all rubber parts in the system, including hoses. Also, when working on the brake mechanisms, check for fluid on linings. If excessive fluid is found, replace pads/shoes.
If master cylinder piston seals are satisfactory, check for leakage or excessive heat conditions. If condition is not found, drain fluid, flush with brake fluid, refill and bleed system.
The system must be flushed if there is any doubt as to the grade of fluid in the system or if fluid has been used which contained parts that have been subjected to contaminated fluid.