Rear Door Window Glass: Service and Repair

Rear Door Glass Removal and Installation

Removal

1) Remove inside handle bezel fitting screw.
2) Remove door armrest or door inside pull handle case.
3) Remove window regulator handle (if equipped). To remove regulator handle, pull off snap ring by using a cloth as shown.






4) Remove door trim (1) with inside weatherstrip. With inside handle bezel (2) tilted as shown in the figure, turn door trim (1) 90� counterclockwise to remove it. And disconnect power window switch lead wire (if equipped).






5) Remove door sealing cover.
6) Remove door outer weatherstrip.

CAUTION: Using a tape-wrapped putty knife (or tape-wrapped screwdriver), pry off weatherstrip. Use of an unwrapped tool will cause damage to painting.

7) Remove glass fitting screws (2). Then down door glass (1).






3. Hole

8) Detach rear part of glass run (1) from center sash (2).






3. Partition glass

9) Remove door center sash (4) (by removing 2 bolts (5) and a screw (1) with door glass (2) lowered all the way down).
10) When remove partition glass (3), slide to front to remove it.






11) Take out glass.

Installation

Reverse removal sequence to install door glass, noting the following points.

- Securely seal door sealing cover (1) with adhesive (2).






- Install door window regulator handle so that it has an angle as shown when glass is fully closed.