System Specifications

Apply engine oil to cylinder head bolts and tighten them gradually as follows.
(1) Tighten all bolts to 35 Nm (25.0 ft. lbs.) according to numerical order in figure.
(2) In the same manner as in 1), tighten them to 55 Nm (40.0 ft. lbs.).
(3) In the same manner as in 1) again, tighten them to specified torque.

Tightening Torque (a): 68 Nm (49.5 ft. lbs.)







To take up slack of timing belt, turn crank shaft two rotations clockwise after installing it. After making sure that belt is free from slack, tighten tensioner stud first and then tensioner bolt to each specified torque.
Then confirm again that two sets of marks are aligned respectively.

Tightening Torque
(a): 11 Nm (8.0 ft. lbs.)
(b): 25 Nm (18.0 ft. lbs.)







Install timing belt outside cover.
Before installing, make sure that seal is between water pump and oil pump case.

Tightening Torque (a): 11 Nm (8.0 ft. lbs.)






Install crankshaft pulley.
Fit keyway of pulley to key on crank timing belt pulley, and tighten 5 bolts to specified torque.

Tightening Torque (a): 16 Nm (11.5 ft. lbs.)








Install crankshaft to cylinder block.
Install bearing cap to cylinder block, making sure to point arrow mark (on each cap) to crankshaft pulley side. Fit them sequentially in ascending order, 1, 2, 3, 4 and 5, starting from pulley side.
After installing bearing cap stiffeners, tighten bearing cap bolts in such order as shown in figure a little at a time and repeat it till they are tightened to specified torque.

Tightening Torque (a): 54 Nm (39.0 ft. lbs.)

NOTE: After tightening cap bolts, check to be sure that crankshaft rotates smoothly when turning it by 8.0 Nm (5.8 ft. lbs.) torque or below.







Install flywheel (M/T model) or drive plate (A/T model).
Using special tool, lock flywheel or drive plate, and torque its bolts to specification.
Special Tool (A): 09924-17810

Tightening Torque (a): 78 Nm (56.5 ft. lbs.)