Chart B - Air Bag Warning Lamp Comes ON Steady

CHART B - "AIR BAG" WARNING LAMP COMES "ON" STEADY

CAUTION:
- When measurements are requested in this chart use specified digital multimeter with correct terminal adapter from special tool (Connector test adapter kit).
- When a check for proper connection is requested refer to "INTERMITTENTS AND POOR CONNECTIONS" in this section.
- When an open in air bag wire harness, damaged wire harness, connector or terminal is found, replace wire harness, connectors and terminals as an assembly.





CHART TEST DESCRIPTION: Number(s) below refer to circled number(s) on the diagnostic chart.

1) An open "AIR BAG" fuse would cause the "AIR BAG" warning lamp to come "ON" steady.
2) A disconnected SDM harness connector will cause the warning lamp to come "ON" steady via the short bar from terminal "A7" to terminal "A6" (ground).
3) This test checks for an open in the "Ignition" circuit to the SDM.
4) This test checks for a short from the "AIR BAG" warning lamp circuit to ground.
5) This test checks whether a short to ground caused the "AIR BAG" fuse to open.
6) This test determines whether the short to ground is due to a short in the wiring.





WIRING DIAGRAM