Brake Band Adjustment

BRAKE BAND ADJUSTMENT





5. While holding servo piston sleeve with wrench, install low brake band adjust bolt till its bottom contacts by using special tool. After tightening it to specified torque once, back it off exactly 5 full turns and tighten lock nut.

NOTE:
^ Make sure that lock nut is fully loosened when adjusting adjust bolt.
^ This adjustment should be performed with transmission placed horizontally.

Initial tightening torque for Brake band adjust bolt:
4.5 Nm (0.45 kg-m, 4.0 inch lbs.)
Back off of brake band adjust bolt: 5 turns

Tightening Torque for lock nut (a): 19 Nm (1.9 kg-m, 14 ft. lbs.)

Special Tool (C): 09900-21102