How to Clear Diagnostic Trouble Codes

1. Turn ignition switch OFF.
2. Connect Tech 1 to data link connector (DLC) in the same manner as when making this connection for DTC check.

Special Tool
(A): 09931-76011 (Tech 1)
(B): Mass storage cartridge
(C): 09931-76030 (16/14 pin DLC cable)

3. Turn ignition switch ON.
4. Erase DTC according to instructions displayed on Tech 1.
Refer to Tech 1 operator's manual for further details.
5. After completing the check, turn ignition switch OFF and disconnect Tech 1 from data link connector (DLC).
6. Perform "Diagnosis Trouble Code (DTC) Check" and confirm that normal DTC (NO CODES) is displayed and not malfunction DTC.

NOTE:
- If DTC 51, DTC 53 or DTC 71 is stored in SDM, it is not possible to clear DTC.
- On-board diagnosis function is not possible to clear DTC.