Lower Valve Body

LOWER VALVE BODY

DISASSEMBLY





1. Remove bypass valve, bypass valve spring, check ball valve damping spring, valve body ball and ball valve spring.





2. Remove lower valve body plate and lower valve body plate gasket.
3. Remove Torque Converter Clutch (TCC) (lock-up) control valve plate and TCC (lockup) control valve gasket.





4. With pressure relief valve retainer pressed with finger, remove pressure relief valve bolt and then remove pressure relief valve retainer, pressure relief valve spring and pressure relief valve ball.





5. Remove TCC (lock-up) solenoid valve and Then remove 0-ring from TCC solenoid valve.





6. After removing shift solenoid valve (A & B), remove solenoid valve gasket, low coast modulator valve spring, intercoast modulator valve spring and 2 intermediate coast modulator valves.





7. Pressing TCC (lock-up) control sleeve with finger and using magnet, remove locating pin and then remove TCC (lock-up) control sleeve, TCC (lock-up) control valve and TCC (lockup) control valve spring.





8. Check which step of primary regulator valve sleeve (how many steps down from its tip) contacts primary regulator valve sleeve retainer.





9. Pressing primary regulator valve sleeve with finger and using magnet, remove primary regulator valve sleeve retainer and then remove primary regulator valve sleeve, primary regulator valve plunger, primary regulator valve spring and primary regulator valve.

ASSEMBLY
Assemble each component by reversing disassembly procedure and noting following points.








^ Coil outer diameter and free length of each valve spring should be as listed. Be sure to use each one of correct size.





^ Install primary regulator valve sleeve so that its tip is positioned as it was before disassembly.
^ Use new TCC (lock-up) control valve gasket, solenoid gasket and lower valve body plate gasket.
^ Tighten shift solenoid valve bolt to specified torque.
Shift solenoid valve bolt tightening torque:
10 Nm (1.0 kg-m, 7.5 ft. lbs.)





^ Tighten TCC (lock-up) solenoid valve bolt to specified torque.
TCC solenoid valve bolt tightening torque:
5.5 Nm (0.55 kg-m, 4.0 ft. lbs.)
^ Tighten pressure relief valve bolt to specified torque.
Pressure relief valve bolt tightening torque:
5.5 Nm (0.55 kg-m, 4.0 ft. lbs.)





^ Tighten lower valve body plate, TCC (lock-up) control valve plate flange bolt to specified torque.
Plate bolt tightening torque:
5.5 Nm (0.55 kg-m, 4.0 ft. lbs.)