Line Pressure Test

LINE PRESSURE TEST





Purpose of this test is to check operating conditions of each part by measuring fluid pressure in fluid pressure line. Line pressure test requires following conditions.
- Automatic fluid is at normal operating temperature (70 to 80° C / 158 - 176° F).
- Fluid is filled to proper level (between FULL HOT and LOW HOT on dipstick).





1. Apply parking brake securely and place checks against wheels.
2. Attach oil pressure gauge to fluid pressure check hole in transmission case.
Special Tool
(A): 09925-37810

CAUTION: After attaching oil pressure gauge, check that not fluid leakage exists.

3. Depress foot brake fully, run engine at idle and stall and then check fluid pressure in "D" or "R" range.

CAUTION: Do not continue running engine at stall speed longer than 5 seconds.





G16/J20 Engines





H25 Engine





Result Table

Tightening torque of transmission case plug: 17 Nm (1.7 kg-m, 12.0 lb-ft)