Clutch Switch: Service and Repair
CLUTCH PEDAL POSITION (CPP) SWITCHREMOVAL
1. Disconnect CPP switch connector with ignition switch "OFF".
2. Remove CPP switch from pedal bracket.
INSTALLATION
1. Install CPP switch to pedal bracket.
2. With clutch pedal released, adjust switch position so that clearance between end of thread and clutch pedal bracket is within specification.
Clearance "a" between end of thread and clutch pedal bracket: 1.5 - 2.0 mm (0.06 - 0.08 in)
3. Tighten lock nut to specified torque.
Tightening torque
CPP switch lock nut (a): 7.5 N.m (0.75 kg-m, 5.5 lb-ft)
4. Connect connector to CPP switch securely.