Counter Shaft and Reverse Idler Gear

COUNTERSHAFT AND REVERSE IDLER GEAR








1. Fit sleeve (4) to counter shaft 5th gear (3), place 3 synchronizer keys (2) in it and then set synchronizer springs (1). Refer to the figure for proper installing direction of gear, sleeve and springs. Also, note that key has specific installing direction.





2. Set inner race (2) to counter shaft front bearing (1) and press-fit bearing with press and special tool.

NOTE: When Installing bearing, bring it so that its groove for circlip is in the front.

Special tool (A): 09940-54950








3. Select circlip that will make its thrust clearance 0.1 mm (0.0039 inch) or less and install it.





Circlip thickness specification:

Special tool (B): 09900-06107