P1410
DTC P1410: Fuel Tank Pressure Control System MalfunctionWiring Diagram / Circuit Description:
DTC Detecting Condition And Trouble Area:
DTC Confirmation Procedure
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester, on a level road.
NOTE: Check to make sure that the following conditions are satisfied when using this DTC CONFIRMATION PROCEDURE.
- Intake air temperature: between -14 °C and 70 °C (6.8 °F and 158 °F)
- Atmospheric pressure: higher than 560 mmHg (Altitude: lower than 2790 m (9150 ft))
1. With ignition switch OFF, connect scan tool.
2. Turn ON ignition switch and clear DTC by using scan tool if any.
3. Start engine and increase vehicle speed to 40 km/h (25 mph) for 1 min.
4. Stop vehicle and check DTC and pending DTC by using scan tool.
Step 1 - 3:
DTC Troubleshooting