Indication of Connectors and How to Read Them

The connectors are indicated as shown in "System Circuit Diagram". For the shape and pin arrangement of each connector, refer to "List of Connectors: G16 and J20 Engine".

Described below are how they are indicated and how to read them.
- The male terminal and female terminal are identified by a double enclosure and a single one respectively.
- The intermediate connector which connects harnesses is shown by both shapes of the male terminal and the female terminal but the connector to be connected directly to the equipment is shown by the shape of the connector on the harness side.
- The connectors are always "harness side connectors" which are viewed from the direction as shown at the right.




- There are three types of connectors with respect to the way it is connected and each type is illustrated as shown.




- Wiring of this vehicle uses joint connectors (J/C) which divide one wire into several different wires or combine several different wires into one wire.
- In the "System Circuit Diagram", pin numbers for joint connectors are omitted because all the same color wires are connected with each other inside the joint connectors, the structure of which can be seen by opening the connector head as shown above.
- The joint connectors is illustrated above.