Clearing Diagnostic Trouble Codes

NOTE: This is the only information provided by the manufacturer for clearing trouble codes for this system.

DTC Clearance (for Engine)
1. With ignition switch OFF, connect OBD-II generic scan tool or SUZUKI scan tool to DLC.
2. Turn ignition switch ON.
3. Erase DTC according to instructions displayed on scan tool. Freeze frame data is cleared with the DTC. Refer to scan tool operator's manual for further details.
4. After completing the clearance, turn ignition switch off and disconnect scan tool from data link connector.

NOTE: DTC and freeze frame data stored in ECM (PCM) memory are also cleared in the following cases. Be careful not to clear them before keeping their record.
- When power to ECM (PCM) is cut off (by disconnecting battery cable, removing fuse or disconnecting ECM (PCM) connectors)
- When the same malfunction (DTC) is not detected again during 40 engine warm-up cycles (refer to WARM-UP CYCLE of "On-Board Diagnostic System Description (for Engine)".) System Description