With Manufacturer's Scan Tool
DTC ClearanceUsing SUZUKI Scan Tool
1. Turn ignition switch to OFF position.
2. Connect SUZUKI scan tool to data link connector (DLC).
Special Tool
(A): SUZUKI scan tool
3. Light over sunload sensor vertically with an incandescent lamp of approx. 100 W apart from about 100 mm (3.94 in.) position.
4. Turn ignition switch to ON position.
5. Erase DTC according to instructions displayed on SUZUKI scan tool. Refer to SUZUKI scan tool operator's manual for further details.
6. After completing the clearance, turn ignition switch to OFF position and disconnect SUZUKI scan tool from DLC.
7. Perform DTC Check and confirm if normal DTC (NO CODES) is displayed.