Without Scan Tool

DTC Clearance

Not Using SUZUKI Scan Tool




1. Check A/C switch indicator (6) for operation referring to A/C Indicator Lamp Check.
2. Light over sunload sensor vertically with an incandescent lamp of approx. 100 W apart from about 100 mm (3.94 in.) position.
3. Set the following selectors to specified positions respectively.
- Temperature selector (1): Max cool position
- Air flow selector (2): AUTO (automatic air conditioning system) or VENT (manual air conditioning system) position.
- Blower speed selector (3): OFF position.

4. Turn ignition switch ON position under the conditions set at the Step 2) and 3) by pushing the A/C switch (4) and air intake switch (5) at the same time.
5. Push A/C switch and air intake switch at the same time.
6. Make sure that rear defogger lamp is lighted.
7. Push rear defogger switch (7) at 3 seconds or more.
8. After completing the clearance, turn ignition switch OFF position.
9. Perform DTC Check, and confirm if normal DTC is displayed and if any other DTC is detected.