Keyless Entry - Transmitter Programming Revisions
Section Title: Body, AccessoriesTSB No. TS 09 09113
Division: Automotive
Category: Technical
SUBJECT:
SERVICE MANUAL UPDATE CORRECTION - REPROGRAMMING PROCEDURE FOR KEYLESS TRANSMITTERS.
MODEL(S):
GRAND VITARA AND XL-7
YEAR:
2003
CONDITION:
Programming procedure in service manual incorrect.
CAUSE:
N/A
CORRECTION:
Update listed Service Manual with correct programming procedure.
AFFECTED SERVICE MANUALS
Programming Transmitter Code
NOTE:
^ Four transmitter codes can be registered at the same time.
^ If a fifth transmitter code is registered, the oldest one will then be cleared. Register four new transmitter code(s) to delete existing registered transmitter code(s).
If transmitter/door lock controller is replaced with new one or additional transmitter(s) is necessary, program transmitter code(s) as follows:
1) Confirm that all the doors are closed and the ignition key is out of the ignition cylinder.
2) Open the driver's door. Insert the key and turn the ignition switch to ON position within 10 seconds.
3) Turn the ignition switch to OFF position within 10 seconds, remove ignition key from lock cylinder.
4) Push and release the driver's door switch (1) 3 times within 20 seconds.
5) Insert the ignition key and turn the ignition switch to ON position within 10 seconds.
6) Turn the ignition switch to OFF position within 10 seconds, remove ignition key from lock cylinder.
7) Press and hold both LOCK and UNLOCK buttons (2) on the transmitter (3) for more than 5 seconds within 20 seconds of removing the ignition key from the lock cylinder in step 6.
8) Press LOCK or UNLOCK button (2) on the transmitter (3) within 5 seconds (after step 7). All the doors will lock/unlock to confirm that this process has been properly done.
With this process, the transmitter has been programmed.
9) If you want to program an additional transmitter, repeat the procedure from Step 1) through Step 8).
10) Make sure that the keyless entry system properly operates by operating each transmitter.