Manual Transmission Rear Case

Disassembly





1) Remove counter shaft gutter (2) from transmission rear case (1).





2) Take out oil seal (1) from rear case (2).





3) Remove interlock cam plug (1) by using torx wrench (2).





4) Remove pin by using special tool.





5) Pull out interlock cam component (1).

Reassembly





1) Check that interlock cam component (1) moves smoothly in both turning direction and sliding direction.





2) Insert interlock cam component (1) to rear case.





3) Set interlock cam component (1) as shown in figure and drive pin by using special tool.





4) Apply thread lock cement to thread of interlock cam plug (1) and tighten it to specification.





5) Install oil seal to rear case so that end surface of oil seal becomes flush with that case. Apply grease to oil seal lip.





6) Install counter shaft gutter (2) to transmission rear case (1).