Blower Motor Case
Blower Unit Removal and InstallationRemoval
1. Disconnect negative (-) cable at battery.
2. Disable air bag system. Refer to Disabling Air Bag System.
3. Open glove box, then remove screw and damper located on the right side of the glove box.
4. Remove glove box.
5. Remove passenger lower member (1).
6. Remove ECM (PCM) with bracket from blower unit.
7. Disconnect blower motor lead wire (1), blower motor relay lead wire (2), and blower motor controller lead wire (3) at couplers.
8. Disconnect air intake actuator coupler.
9. Remove fastening nuts (1) and screw (2), and then remove blower unit (3).
Installation
1. Reverse removal procedure for installation.
2. Enable air bag system. Refer to Enabling Air Bag System.