DTC Clearance for SDM
DTC Clearance for SDMUsing SUZUKI Scan Tool
1. Turn ignition switch to OFF position.
2. Connect SUZUKI scan tool to data link connector (DLC) in the same manner as when making this connection for DTC check.
Special Tool
(A) : SUZUKI scan tool
3. Turn ignition switch to ON position.
4. Erase DTC according to instructions displayed on SUZUKI scan tool. Refer to SUZUKI scan tool operator's manual for further details.
5. After completing the check, turn ignition switch to OFF position and disconnect SUZUKI scan tool from DLC.
6. Perform DTC Check for SDM:H27 Engine Model (Advanced Air Bag) and confirm that normal DTC (NO CODES) is displayed and not malfunction DTC. DTC Check For SDM
NOTE: If DTC B1013 or DTC B1021 is stored in SDM, it is not possible to clear DTC.
Not Using SUZUKI Scan Tool
1. Turn ignition switch to ON position and wait about 6 seconds or more.
2. Using service wire (4), repeat shorting and opening between diagnosis switch terminal (3) on "AIR BAG" monitor coupler (1) and body ground (2) 5 times at about 1 second intervals.
3. Perform DTC Check for SDM:H27 Engine Model (Advanced Air Bag) and confirm that normal DTC (No. 0000) is displayed and not malfunction DTC. DTC Check For SDM
NOTE: If DTC B1013 or DTC B1021 is stored in SDM, it is not possible to clear DTC.