Camshaft Position Sensor: Service and Repair

Camshaft Position (CMP) Sensor Removal and Installation

CAUTION: Disassembly is prohibited. If anything faulty is found, replace as an assembly unit.

Removal
1. Disconnect CMP sensor coupler (2)
2. Remove A/T fluid level gauge (4) and filler tube (5)




3. Remove CMP sensor (1) by removing bolt (3)

Installation
Reference: Ignition Timing Check and Adjustment




1. Install a new O-ring (2) with engine oil applied to CMP sensor (1)




2. Install CMP sensor (1) to camshaft (3)
Fit the dog of CMP sensor coupling (2) into the slots of camshaft, when installing. The dogs of CMP sensor coupling are offset. Therefore, if the dogs can not be fitted into the slots, turn the CMP sensor shaft by 180 degree and try again.

3. Tighten CMP sensor bolt (3)




4. Connect CMP sensor coupler (2) to CMP sensor (1)




5. Install A/T fluid level gauge (1) and filler tube (2)