Radio/Stereo: Service and Repair
Radio Assembly Removal and InstallationRemoval
1. Disconnect negative (-) cable at battery.
2. Remove center lower garnish (1).
3. Remove center garnish mounting screw (1) and then pull off center garnish.
4. Remove harness and controller cover (2).
5. Disconnect BCM connectors and HVAC control module connector from each controller.
6. Remove center garnish (1) with BCM (2) and HVAC control module.
7. Remove 4 mounting screws (3) of radio assembly (4).
8. Remove radio assembly (4) from instrument panel.
9. Disconnect radio assembly coupler and antenna feeder from radio assembly (4).
Installation
Reverse removal procedure to install radio assembly noting the following point.
- When installing center garnish, align rubber bushing (1) with BCM installation hole (2) of instrument panel member (3).