Scan Tool Data Definitions

Scan Tool Data Definitions.

VEHICLE SPEED (km/h, MPH): It is computed based on pulse signals from vehicle speed sensor on transfer or transmission.

IGNITION SWITCH (START / ON):
START: Ignition switch is at start position.
ON: Ignition switch is at ON position .

KEY REMINDER SWITCH (KEY IN / PULLED): It is detected by key reminder switch.

REAR WIPER SWITCH (OFF / ON / INT):
OFF: Rear wiper switch is at OFF position.
ON: Rear wiper switch is at ON and WASH/WIPER position.
INT: Rear wiper switch is at INTERMITTENT position.

REAR WASHER SWITCH (OFF / ON): This parameter indicates the state of the rear windshield washer switch.

WASHER LEVEL (Normal / Low):
Normal: Normal condition. (if vehicle is not equipped with Windshield washer tank switch, this parameter indicates Normal even if windshield washer tank is empty.)
Low: Windshield washer tank level is lower than specified level.

FRONT FOG LIGHT SWITCH (OFF / ON): This parameter indicates the state of the front fog light control signal.

DOOR KEY SWITCH (Driver side / Passenger side and back door key switch, Neutral / LOCK / UNLOCK):
Neutral: All door key switch is neutral position.
LOCK: Any one of the door key switch is lock position.
UNLOCK: Driver side door key switch is unlock position.

DOOR LOCK SWITCH (Both side manual lock switch, Neutral / LOCK / UNLOCK): This parameter indicates the state of the manual lock switch.

DRIV DOOR SWITCH (Driver side door switch, CLOSE / OPEN): This parameter indicates the state of the driver side door switch.

PASS DOOR SWITCH (All door switch, CLOSE / OPEN):
CLOSE: All door switch is close position.
UNLOCK: Any one of the door switch (including driver side door switch) is unlock position.

AUTO LIGHT SWITCH (OFF / ON): This parameter indicates the state of the auto-on headlight switch in headlight switch.

PARKING BRAKE SWITCH (OFF / ON):
OFF: Parking brake lever released
ON: Parking brake lever pulled up .

REAR DEFOGGER SWITCH (OFF / ON): This parameter indicates the state of the dear defogger switch.

HEADLIGHT SWITCH (OFF / PARKING / HEADLIGHT): This parameter indicates the state of the headlight switch.

DIAG SWITCH TERMINAL (Diagnosis switch terminal, OPEN / GROUND):
OPEN: Normal condition.
GROUND: Diagnosis switch terminal in monitor coupler shorts to ground circuit.

DRIV SEAT BELT SWITCH (Driver side seat belt buckle switch, FASTEN / UNFASTEN): This parameter indicates the state of the driver side seat belt buckle switch.

BRAKE: Normal: Normal condition.

FLUID LEVEL (Normal / Low): Low: Brake fluid level is lower than specified level.

ILLUMI INTENSITY (Illumination intensity control, %): When illumination controller is fully closed position, illumination intensity is indicated as 30% and 100% for full open position.

SUN INTENSITY (Sunlight intensity / Lxs): It is detected by auto light sensor.