With Generic Scan Tool
DTC ClearanceUsing SUZUKI Scan Tool
1. Turn ignition switch to OFF position.
2. Connect SUZUKI scan tool to data link connector (DLC).
Special Tool
(A) : SUZUKI scan tool
3. Turn ignition switch to ON position.
4. Erase DTC according to instructions displayed on SUZUKI scan tool. Refer to SUZUKI scan tool operator's manual for further details.
5. After completing the clearance, turn ignition switch to OFF position and disconnect SUZUKI scan tool from DLC.
6. Perform DTC Check:Manual Type and confirm if normal DTC (NO CODES. is displayed. With Manufacturer's Scan Tool
Not Using SUZUKI Scan Tool
1. Check A/C switch indicator (6) for operation referring to A/C Indicator Lamp Check: Manual Type.
2. Set the following selectors to specified positions respectively.
- Temperature selector (1): Max cool position
- Air flow selector (2): "VENT" position.
- Blower speed selector (3): "OFF" position.
3. Turn ignition switch ON position under the conditions set at the Step 2) by pushing the A/C switch (4) and air intake switch (5) at the same time.
4. Push A/C switch and air intake switch at the same time.
5. Make sure that rear defogger lamp is lighted.
6. Push rear defogger switch (7) at 3 seconds or more.
7. After completing the clearance, turn ignition switch OFF position.
8. Perform DTC Check:Manual Type, and confirm if normal DTC is displayed and if any other DTC is detected. With Manufacturer's Scan Tool