Turn Signal and Hazard Warning Lights System Circuit Inspection

TURN SIGNAL AND HAZARD WARNING LIGHTS SYSTEM CIRCUIT INSPECTION

1. Disconnect negative ( ) cable from battery.




2. Disconnect turn signal and hazard warning relay (1) connector "E218".
3. Connect negative ( ) cable to battery.




4. Confirm that right or left side turn signal lights turn on when connecting "E218-4" terminal to "E218-2" or "E218-3" terminal with service wire. If turn signal light does not turn on, check bulb or repair applicable circuit.







5. Check for voltage and continuity between the following each terminal and body ground under each condition. If check result is not as specified, repair applicable circuit. If all check result are OK, replace turn signal and hazard warning relay and recheck.