Select Cable Adjustment
Select Cable Adjustment1. Loosen manual select cable end nut (1).
2. Shift select lever to "N".
3. Align center line (2) on manual shift shaft (3) to "N" reference line (4) as shown in figure.
4. Tighten manual select cable end nut (1) to specified torque.
5. After select cable was installed, check for the following.
^ Push vehicle with selector lever shifted to "P". Vehicle should not move.
^ Vehicle can not be driven in "N".
^ Vehicle can be driven in "D", "3" and "L".
^ Vehicle can be backed in "R".