Input Shaft Bearing Retainer and Oil Seal Disassembly and Assembly
Input Shaft Bearing Retainer and Oil Seal Disassembly and AssemblyReference: Manual Transmission Assembly Dismounting and Remounting
Reference: Manual Transmission Unit Disassembly
Reference: Input Shaft Disassembly and Assembly
Disassembly
1. Set bearing retainer (2) on vise (3) securely.
NOTE: Use aluminum plates between vise (3) and bearing retainer (1) to protect bearing retainer against damage.
Remove oil seal (1) from bearing retainer (2) using special tool if necessary.
NOTE: Unless oil seal (1) is leaky or its lip is excessively hardened, replacement is not necessary.
Assembly
Press-fit new oil seal (2) to bearing retainer (1) up to the specified position using special tool as shown in the figure.
Apply grease to oil seal lip.
: Grease 99000-25010
Special Tool
(A): 09913-75821
(B): 09924-84510-004
Oil seal installing position
a: 11.2 - 12.2 mm (0.44 - 0.48 inch)
