Instrument Panel

Instrument Panel Removal and Installation

WARNING:
- Refer to Air Bag Warning before starting service work.

CAUTION:
- Position heat control mode into FOOT MODE before removing instrument panel to avoid the damage to air flow control door.

Removal
1. Disconnect negative cable at battery.




2. Remove driver side instrument panel under cover (1) and passenger side instrument panel under cover (2).
3. Disable air bag system referring to Disabling Air Bag System:Advanced Air Bag or Disabling Air Bag System:Except Advanced Air Bag.
4. Remove steering column hole cover (1).
5. Turn steering wheel to remove steering column cover screws (3).




6. Remove steering column covers (2).
7. Remove glove box (1).




8. Remove hood latch release lever (2).
9. Remove console box referring to Console Box Components.




10. Remove front pillar trims (1) front side sill scuffs (2) and dash side trims (3).
11. Disconnect instrument panel harness connectors, inside air temperature sensor duct and antenna cable instrument panel removal.
12. Remove steering column mounting referring to Steering Column Assembly Removal and Installation.
13. Remove instrument panel ground wire.
14. Remove instrument panel mounting bolts (1).




15. Remove instrument panel (2) with steering support member and instrument panel harness.

Installation
Reverse removal procedure noting the following.
- When installing each part, be careful not to catch any cable or wiring harness.
- Tighten instrument panel mounting bolts to specified torque




Tightening torque
Instrument panel mounting bolt a: 23 Nm (2.3 kg-m, 17.0 lb-ft)

- Tighten steering column mounting nuts referring to Steering Column Assembly Removal and Installation.
- Enable air bag system referring to Enabling Air Bag System:Advanced Air Bag or Enabling Air Bag System:Except Advanced Air Bag.