Manual Transmission Unit Disassembly
Manual Transmission Unit Disassembly1. Remove clutch operating cylinder assembly from transmission front case.
2. Remove gear shift control lever rear cause assembly and gear shift lever front case assembly.
3. Separate transfer assembly (1) or extension case from transmission assembly.
4. Remove adapter case (1) from rear case (2).
5. Remove output shaft assembly (3) from adapter case.
6. Remove reverse shaft bolt (1) and back up light switch (2).
7. Remove gear shift locating bolts (1), then take out locating springs (2) and gear shift shaft balls (3).
8. Remove rear to front case bolts (4), then separate rear case from front case tapping front case flange with plastic hammer.
9. Remove oil gutter.
10. Remove reverse shaft assembly (1).
11. Remove low gear shift inverse lever (4).
12. Remove low speed gear shift shaft (2) and 5th & reverse gear shift fork (3) with 5th speed synchronizer sleeve (5).
13. Remove input shaft needle bearing, 5th speed synchronizer ring and 5th speed synchronizer levers.
14. Remove input shaft front bearing circlip (1) from case using special tool.
15. Remove input shaft assembly (1), countershaft assembly (2), high speed gear shift fork (3) and low speed gear shift fork (4) as assembly from front case (5) tapping input shaft end by plastic hammer lightly.
