Rear Door Window Glass: Service and Repair

Rear Side Door Window Replacement

Removal Procedure
1. Remove the inner rear door trim panel.






2. Remove the inner belt seal.
3. Remove the rear door water deflector.
4. Remove the door frame appliques.






5. Lower window to access the window release tab.






6. Remove the window run channel bolts and loosen the window run channel.
7. Depress the window release tab with a flat-bladed tool.
8. Pull the window out of the window regulator guide plate.
9. Slide the window down and out of the primary window run channels.
10. Remove the window through the door belt opening.

Installation Procedure






1. Install the window by sliding the window into the door through the outside door belt opening.
2. Install the window into the primary window run channels and position into the regulator guide plate.






CAUTION: Refer to [Fastener Notice] in Cautions and Notices.

3. Install the window run channel bolts.

Tightening torque
Tighten the bolts to 8 N.m (71 lb in).

4. Install the rear door water deflector.






5. Install the inner belt seal.
6. Install the rear inner door trim panel.
7. Install the door frame appliques.
8. Operate the window to inspect the operation.