Power Steering Cooler Pipe/Hose Replacement
Power Steering Cooler Pipe/Hose ReplacementRemoval Procedure
1. Remove the fuel injector sight shield.
2. Remove the air cleaner outlet duct.
3. Remove the front tire/wheel assemblies.
4. Remove the left side engine splash shield.
5. Place drain pans under the vehicle as needed.
6. Compress the power steering cooler pipe clamp (1) and disconnect the power steering cooler pipe (2) from the remote power steering fluid reservoir.
7. Disconnect the power steering cooler pipe fitting (1) from the power steering gear.
8. Unclip all power steering cooler pipe routing brackets.
9. Remove the power steering cooler pipe from the vehicle.
Installation Procedure
1. Position the power steering cooler pipe to the vehicle.
2. Reconnect all power steering cooler pipe routing brackets to the vehicle.
CAUTION:
Refer to Fastener Notice.
3. Connect the power steering cooler pipe fitting (1) to the power steering gear.
Tightening torque
Tighten to 25 Nm (18 ft. lbs.).
4. Compress the power steering cooler pipe clamp (1) and connect the power steering cooler pipe (2) to the remote power steering fluid reservoir.
5. Clean any excess fluid from the vehicle and remove the drain pans.
6. Install the left side engine splash shield.
7. Install the front tire/wheel assemblies.
8. Install the air cleaner outlet duct.
9. Install the fuel injector sight shield.
10. Fill and bleed the power steering system.