Camshaft Position Sensor Replacement - Bank 2 (Left Side) Exhaust

Camshaft Position Sensor Replacement - Bank 2 (Left Side) Exhaust




Removal Procedure
1. Remove the air cleaner assembly. Refer to [Air Cleaner Assembly Replacement].




2. Disconnect the engine wiring harness electrical connector (6) from the bank 2 exhaust camshaft position (CMP) sensor.
3. Remove the CMP sensor bolt.
4. Remove the CMP sensor.




Installation Procedure
1. Install the CMP sensor.

CAUTION: Refer to [Fastener Notice].




2. Install the CMP sensor bolt.

Tightening torque
Tighten the bolt to 10 N.m (89 lb.in).

3. Connect the engine wiring harness electrical connector (6) to the bank 2 exhaust CMP sensor.
4. Install the air cleaner assembly. Refer to [Air Cleaner Assembly Replacement].