Camshaft Position Sensor Replacement - Bank 1 (Right Side) Exhaust

Camshaft Position Sensor Replacement - Bank 1 (Right Side) Exhaust




Removal Procedure
1. Remove the air cleaner assembly. Refer to [Air Cleaner Assembly Replacement].




2. Disconnect the engine wiring harness electrical connector (1) from the bank 1 exhaust camshaft position (CMP) sensor.
3. Remove the CMP sensor bolt.
4. Remove the CMP sensor.




Installation Procedure
1. Install the CMP sensor.




2. Install the CMP sensor bolt.

Tightening torque
Tighten the bolt to 10 N.m (89 in. lbs.).

3. Connect the engine wiring harness electrical connector (1) to the bank 1 exhaust CMP sensor.
4. Install the air cleaner assembly. Refer to [Air Cleaner Assembly Replacement].