Scan Tool Data Definitions - Starting and Charging

SCAN TOOL DATA DEFINITIONS - STARTING AND CHARGING

Battery Voltage The scan tool displays 0-20 Volts. The scan tool displays the voltage as received by the Module.

Battery Voltage Signal The scan tool displays 0-20 Volts. The scan tool displays the voltage as received by the Module.

Crank Request Signal The scan tool displays Yes/No. The scan tool displays No until the ignition is placed into the START position then Yes is displayed.

GEN F-Terminal Signal The scan tool displays 0-100%. The display indicates the generator F terminal duty cycle in percent. The scan tool displays 0-5 % until the engine is running, then the percentage value varies depending on engine or electrical loads.

GEN-L Terminal Command The scan tool displays 0-100%. The scan tool displays the percentage of the output voltage of the generator.

GEN-L Terminal Circuit Status The scan tool displays Incomplete, Short Gnd / Open, Short to B+ , or OK. The scan tool displays the status of the GEN L Terminal circuit.

Ignition 1 Signal The scan tool displays 0-20 Volts. The scan tool displays the voltage as received on the Ignition 1 circuit to the module.

Ignition Accessory Signal The scan tool displays ON/OFF. The scan tool displays if the ignition 0 signal is On or OFF.

Ignition Voltage Signal The scan tool displays Present/Not Present. The scan tool displays the status of the ignition voltage signal on the theft deterrent module (TDM).

PNP Switch (If Equipped) The scan tool displays Park/Neutral or In Gear. The scan tool displays the position of the transmission setting.

Start Disabled The scan tool displays YES/NO. The scan tool displays YES if the TDM has disabled the starting function.

Starter Relay Command The scan tool displays ON/OFF.The scan tool displays Off until the ignition is placed into the CRANK position, then it reads On.

Starter Relay Circuit Status The scan tool displays Incomplete, Short Gnd/Open, Short to B+, or OK. The scan tool displays the status of the STRTR relay.

Start Up State of Charge The scan tool displays 1-100%. The scan tool displays the state of charge at initial key up.

Prev. State of Charge The scan tool displays 0-100%. The scan tool displays the state of charge from the previous ignition cycle.

State of Charge The scan tool displays 0-100%. The scan tool displays the present state of charge.

State of Charge Low The scan tool displays YES/NO. The scan tool displays YES if the present state of charge is low.