Holding Fixture Installation
Holding Fixture InstallationSpecial Tool
DT-48355 Holding Fixture
J 3289-20 Holding Fixture
1. Remove the vent hose (814).
2. Remove the transmission vent pipe (812).
3. Install the body of the DT-48355 with the two long bolts (1) to the transaxle.
4. Loosely install the arm and bolt (2) to the DT-48355 body.
CAUTION:
Refer to [Fastener Notice]
5. Install the arm with the provided shorter bolt (3) to the transaxle.
Tightening torque
Tighten the DT-48355 to 25 Nm (18 ft. lbs.) starting with bolt (3).
6. Install the DT-48355 in the J 3289-20.